Activated Carbon From Saw Dust – Small Business Project

Activated carbon from saw dust manufacturing project can be initiated as small scale basis with substantial capital investment. Carbon is probably the most widely available mineral in nature. Activated carbon, active carbon or active charcoal is usually applied to amorphous carbons processing as it has higher absorption capacities than wood or animal charcoal.

Industrial activated carbon from saw dust generally comes in the form of pellets, granules or fine powder. industrial applications are available in the market under different trade names. At present, in India, there are about 30 to 35 units in which four units are in the state of Gujarat. There exists very good scope for this product and it can be explored smartly. There is also huge demand of activated carbon in the export market for the high quality activated carbon. There is certainly wide scope for a new entrepreneur can enter in this project.

Activated carbon from saw dust generally prepared by Zinc Chloride activation in different activation condition. Activated carbon is one of the most important microporous adsorbents due to its
tremendous absorptive capacity. It has an affinity for a variety of dissolved organics and ability
to be custom-tailored to suit the specific application.

It is particular interest to select the sawdust as the raw material to make activated carbon instead of other abundant sources such as clay minerals, rice husks, nut shells, etc.

Activated Carbon From Saw Dust Manufacturing Process

The waste sawdust was collected from a local sawmill. The sawdust was sieved in order to obtain a desirable size fraction (0.5 and 1mm). Then, the sieved sawdust was washed with distilled water to remove any residues or impurities such as ash and dust. Subsequently, it was dried in an oven for 12 hours at 80o° C.
After the sawdust was dry, the material was pyrolyzed in a fluidised bed furnace at different temperature range. The pyrolysis process was undergone at temperature 300, 400 and 500° C for half an hour. Then, the char produced was discharged from the first cyclone of the fluidised bed furnace. This fast pyrolysis method produced a variety of char at a different temperature.

Also, Read Activated Carbon From Coconut Shell  Small Business Project

Activation of the char was done by using steam average flow rate 300 cc/min at temperature 800° C in a muffle furnace for 1 and 2 hours. The activated carbon was then ground and dried in an oven at 100°C for overnight.

Activated Carbon From Saw Dust Project Cost:

Plant Capacity: 2.0 Ton/Day Plant & Machinery: Rs. 30 Lakhs
Working capital: Rs. 30 Lakhs  T.C.I: Rs. 120 Lakhs
Return: 35.00% Break Even: 46.23%
  • The actual cost of the project may deviate on change of any of the assumptions.
  • We can modify the project capacity and project cost as per your requirement.